Complete Slabbing system.
Introducing our 2019 model dedicated slabber. We’ve re-configured this design to offer significant advantages over other manufacturer options. Easy to setup and easy to push through the log, thanks to the faster running chain speed and angled bar!
Length is not a problem either! We can extend this unit as long as you wish.
Electric start 13hp Honda vertical shaft engine.
2 x RX27 chain loops.
Increased output speed (5,500 RPM) for faster cutting.
Centrifugal clutch for easy start up.
Jockey wheels for easy transport and setup.
180 degree easy access for removal of slabs and loading logs.
Easy belt and chain tension system.
Easy bar alignment adjustment.
Stability roller for further rigidity while slabbing.
Angled bar providing for:
Smooth entry and exit of the log.
Easier feed as the chain tends to pull the saw through the cut.
Reduced tendency of frame sway (as seen on other manufacturers products).
1.6m (60”) slab width capacity. 1.6m diameter log.
325m (13”) slab thickness.
5m log length.
Log setup taper alignment included.
DED-13M with electric start Honda GXV390 motor, complete unit including frame. $10,000.
DED-7.5M with (industrial 7.5hp) electric 3 phase 5.5kw DOL motor, complete unit including frame. $10,500.
DED-13M with electric start Honda GXV390 motor, trolley only. $6,000.
DED-7.5M with (industrial 7.5hp) electric 3 phase 5.5kw DOL motor, trolley only. $6,500.
What makes our mills stand out?
Open access to load your logs and remove timber (without the possibility of damaging your tracks. You're not stuck in a portal restricting your options.
The mono rail means you're mill will always pull straight - its not dependent on how or where you pull. It will cut straight no matter what.
We have full taper ability along with single end sizing, making our mills very easy to align to the log and to set you're sizes.
The swing apparatus is effortless. We also have weather board options available to coincide with its simplicity.
All our mills have the ability to double cut straight off the log - no turning the mill around (its designed into the concept). Our mills don't require any 180 degree swing function - this facility has no relationship to any extra ability regarding double cutting.
Portability. Our mills can be provided with a simple dolly trailer system. They can also be transported via a small jockey arrangement optional with the sawmill. They do break down too. Lots of options for easy 10-30 minute setup/breakdown.
A major hidden advantage with our saw is that there is no need to start vertical first followed by horizontal as your finishing cut. Simply start horizontal and finish with vertical - no wedging required. Just grab your cut timber and start again.
Sharpening takes literally seconds with our simple 2-tooth saw blade. This is a special blade to utilize domestic plug in 10 amp supply.
We have slabber and planer blade attachments available for this mill.
Saw any diameter logs.
Price, production, simplicity and portability - you cant beat it!